Connecting Modems To The Core Switch 2/64 - HP AA-RS2WC-TE Installation Manual

Setting Up and Configuring Modems

Connecting Modems to the Core Switch 2/64

Note:
connecting it to the fabric is recommended.
The following items are required to set up two modems to work with the Core
Switch 2/64:
To connect modems to the Core Switch 2/64:
1. Optionally power off the Core Switch 2/64.
2. Set up the two modem units and corresponding power connections.
Note:
3. Connect the modem cables to the modems and to the Core Switch 2/64
4. Connect the telephone line inputs on the modems to the RJ-11 Y connector.
5. Optionally connect a telephone handset to one of the phone connections on
218
Setting up the modems before powering on the Core Switch 2/64 and
Two Hayes-compatible modems, such as the Zoom/Modem V.92 EXT Model
3049
Two standard modem cables, DB25 (male) to DB9 (female)
One RJ-11 Y adapter for standard telco wiring or equivalent circuitry (3 total
connections)
One analog telephone line
Caution: HP recommends powering off the Core Switch 2/64 before
connecting cables to the modem ports. HP also recommends powering off the
Core Switch 2/64 before connecting cables to the modem ports.
Do not power on the modems until all cables are attached.
RS-232 modem ports, as shown in
This effectively places both modems on a single telephone line.
the modems, as shown in
Figure 46.
Figure 46.
Core Switch 2/64 V4.1 Installation Guide