Restoring System Configuration Settings - HP StorageWorks MSA 2/8 - SAN Switch Installation Manual

Restoring System Configuration Settings

Use these steps to restore the system configuration settings from a backup.
1. Verify that the RSHD service or the FTP service is running on the host
2. Log in to the switch as the admin user.
3. At the command line, shut down the switch by entering:
4. Enter:
Note:
5. Restart the switch by entering:
MSA SAN Switch 2/8 Installation Guide
computer.
SWITCHDISABLE
Because the switch is disabled, a warning message about the switch status is
displayed.
CONFIGDOWNLOAD HOSTIPADDR USER PATH_FILENANME PASSWORD
where is the IP address of the host computer,
HOSTIPADDR
ID used to log into this computer,
filename of the configuration file, and
ID specified.
The password operand is required only if you are using FTP.
If only
CONFIGDOWNLOAD
parameter, as shown in the following example:
switch:admin> configdownload
Server Name or IP Address [host]: www.xxx.yyy.zzz
User Name [user]: admin
File Name [config.txt]: switch1
Protocol (RSHD or FTP) [rshd]: ftp
Password:
Download Complete
FASTBOOT
Backing Up Configuration Data and Upgrading Firmware
PATH_FILENAME
PASSWORD
is entered, the system will prompt you for each
is the User
USER
is the path location and
is the password for the User
53