Table of Contents
Advertisement
Technical Specifications
Memory Specifications
Each CP card contains the following memory:
Note:
guaranteeing full transmit and receive bandwidth to all Fibre Channel ports at all
times.
The CP card operates with a lithium carbon-monoflouride coin cell battery. The
battery type and specifications are listed next:
Each CP card contains a serial port with a DB-9 connector, and an RS-232 signal
subset.
Note:
discharge (ESD) particles from entering the port. When the serial port is not in use,
make sure to replace the serial port cover. The terminal serial port is intended
primarily for use during the initial setting of the IP address and for service purposes.
Use the serial port to connect to a computer workstation or terminal without
connecting to the fabric. Configure the terminal device using these settings:
180
Main memory: 256 MB SDRAM (32 Bits wide)
Flash memory:
— User flash: 16MB of 16-bit wide memory, stored in two 8MB banks
— Compact flash: 256MB, partitioned in two 128MB sections
Boot flash: 512K bytes of 8-bit for system boot
The centralized memory maximizes the overall switch throughput by
Rayovac BR 1225
3.0 volt, 50 mAh
WARNING:
There is danger of explosion if the battery is incorrectly
replaced. Discard all used batteries according to the manufacturer's
instructions. Contact your Core Switch 2/64 supplier if the real time clock
begins to lose time.
A serial port cover is included with the switch to prevent dust and electrostatic
Core Switch 2/64 V4.1 Installation Guide
Advertisement
Table of Contents
