Set Setup System; System Configuration Settings - HP AK241A - StorageWorks 8Gb Simple SAN Connection Cli Manual

set setup system

Description Configures the network, session, and logging settings on the switch.
Authority Admin session
Syntax
set setup system
Prompts you in a line-by-line fashion to change system configuration settings.
system configuration parameters. For each parameter, enter a new value or press Enter to accept the
current value shown in brackets.
NOTE: Changing the IP address will terminate all Ethernet management sessions.
Table 43

System configuration settings

Parameter
EthNetworkDiscovery
EthNetworkAddress
EthNetworkMask
EthGatewayAddress
AdminTimeout
InactivityTimeout
LocalLogEnabled
RemoteLogEnabled
RemoteLogHostAddress
NTPClientEnabled
Description
Ethernet boot method:
•
1—Static
• 2—Bootp (Bootstrap Protocol)
• 3—DHCP (Dynamic Host Configuration Protocol)
• 4—RARP (Reverse Address Resolution Protocol)
The default is 1—Static.
Ethernet IP address. The default is 10.0.0.1.
Ethernet subnet mask address. The default is 255.0.0.0.
Ethernet IP address gateway. The default is 10.0.0.254
Amount of time in minutes the switch waits before terminating an
idle Admin session. Zero (0) disables the time out threshold. The
default is 30, the maximum is 1440.
Amount of time in minutes the switch waits before terminating an
idle telnet command line interface session. Zero (0) disables
the time out threshold. The default is 0, the maximum is 1440.
Enables (True) or disables (False) the saving of log information
on the switch. The default is True.
Enables (True) or disables (False) the recording of the switch
event log on a remote host that supports the syslog protocol. The
default is False.
The IP address of the host that will receive the switch event log
information if remote logging is enabled. The default is
10.0.0.254.
Enables (True) or disables (False) the NTP client on the switch.
This client enables the switch to synchronize its time with an NTP
server. This feature supports NTP version 4 and is compatible with
version 3. An Ethernet connection to the server is required and you
must first set an initial time and date on the switch. The
synchronized time becomes effective immediately. The default is
False.
8/20q Fibre Channel Switch command line interface guide 185
Table 43 describes the