Table of Contents
Advertisement
Installing and Configuring the Core Switch 2/64
4. Position the pallet so that the bottom of the chassis is level with the
5. If the chassis is on a pallet jack or lift, stabilize the pallet jack or lift to prevent
Installing the Core Switch 2/64 on a Flat Surface
Use these steps to install the Core Switch 2/64 on a flat surface.
Note:
side of the chassis having access to cool air. Orient the switch so that the port side
faces the service aisle.
1. Remove the switch chassis door, if you have not already done so.
2. Place the Core Switch 2/64 on a flat, sturdy surface like a table or lab bench.
3. Connect the two power cables to the power supply inlets on the switch.
Note:
ensuring redundancy.
4. Connect the two power cables to corresponding power outlets. Make sure that
5. Turn on power to the switch. The switch automatically runs a Power On Self
Note:
instructions on how to set the IP address, see
Addressing, on page 75 later in this chapter.
46
installation surface.
it from moving during the transfer.
WARNING:
A fully populated StorageWorks 14U chassis weighs
approximately 250 lbs (113 kg) and requires a minimum of two people to
safely slide it from one surface to another.
The Core Switch 2/64 must be placed on a stable, flat surface, with the blower
the Chassis
Door, on page 45
It is recommended to power the switch using two separate power sources,
the power cable is routed so that it is not exposed to stress.
Test (POST).
Do not connect the switch to the network until the IP address is correctly set. For
.
Configuring Core Switch 2/64 Network
Core Switch 2/64 V4.1 Installation Guide
Removing
Advertisement
Table of Contents
