HP AA-RS2WC-TE Installation Manual page 130

Installing Core Switch 2/64 FRUs
3. To install the new 16-port card or filler panel in the slot (see
Note:
protection from dust.
130
e. Wait for the Power LED to turn off.
Caution: If removing a 16-port card, wait for the Status LED to turn off before
removing the card.
f. Disconnect any SFP transceivers and cables from the 16-port card.
g. Slide the 16-port card out of the chassis.
page 131):
Install a filler panel in any empty slots to ensure proper chassis cooling, and
For a port card or a filler panel that has ejector handles:
a. Orient the 16-port card or filler panel so that the ejectors are at the front of
the chassis and the flat side of the 16-port card or filler panel is on the left.
b. Align the flat side of the 16-port card or filler panel inside the upper and
lower rail guides in the slot.
c. Slide the 16-port card or filler panel into the slot, with slight pressure to
the left, until it is firmly seated.
Figure 29
Core Switch 2/64 V4.1 Installation Guide
on