Table of Contents
Advertisement
Installing and Configuring the Core Switch 2/64
Setting Network Addresses via a Network Connection
Use these steps to set Core Switch 2/64 network addresses.
1. Verify that switch power is on, and POST is complete.
Note:
cards display a steady green light. For a description of LED patterns, see
Operating the Core Switch
2. Log onto the CP card installed in slot 5 by establishing a serial connection to a
Figure 20: CP card serial port location
76
Post is complete when all power LED indicators on the 16-port cards and CP
workstation running a terminal emulator application (such as HyperTerminal
on Windows or TERM in a Unix environment).
a. Disable any serial communication programs running on the workstation
(such as synchronization programs for a PDA).
b. Remove the shipping cap from the terminal serial port on the CP card in
slot 5, and insert the serial cable, see
2/64.
Figure
SHR-2515A
Core Switch 2/64 V4.1 Installation Guide
Chapter
20.
3,
Advertisement
Table of Contents
