Table of Contents
Advertisement
Installing the Switch in the Optional HP System/e Rack
This section provides instructions for installing the switch in the HP System/e
rack. The following hardware is required to install the optional HP System/e Rack
Mount Kit:
Core Switch 2/64 V4.1 Installation Guide
Do not connect the switch to the network until the IP addresses are
Caution:
correctly set. Refer to the section
Addressing
on page 75.
Rails, rear mounting brackets
Rail mounting hardware, as listed in the following table:
(6) #8-32 x 5/16 Phillips pan-head screw with captive star lock
washer
(6) #8 Flat washer
(6) M5 Torx head screw with captive lock washer
(2) Rubber washer
(4) M5 U-type Tinnerman clip
Installing and Configuring the Core Switch 2/64
Configuring Core Switch 2/64 Network
61
Advertisement
Table of Contents
