Table of Contents
Advertisement
Figure 29: Alignment guides in card slots
4. Verify that the 16-port card was installed properly as follows:
Core Switch 2/64 V4.1 Installation Guide
d. Close the ejectors by rotating the black handles toward the center of the
16-port card or filler panel until the ejectors lock. The levering action of
the handles seats the 16-port card or filler panel in the slot.
For a filler panel that does not have ejector handles, align the flat side of
the filler panel inside the upper and lower rail guides in the slot, and slide
the filler panel into the slot, with slight pressure to the left, until it is
firmly seated.
Caution:
Do not force the card or filler panel in the slot. If the 16-port card or
filler panel does not slide in easily, adjust the alignment with the rail guides
accordingly.
a. Check that the 16-port card power status LED shows a steady green light
(it may require a few seconds to turn on).
b. Check that the 16-port card is firmly seated. The front of the 16-port card
should be flush with adjacent 16-port cards or filler panels.
Installing Core Switch 2/64 FRUs
SHR-252
131
Advertisement
Table of Contents
