Table of Contents
Advertisement
Installing and Configuring the Core Switch 2/64
I
Rubber washer (1 of 2)
1
Figure 14: Installing the rubber washers
6. Install one M5 Torx screw in the upper hole location of the right rail. Then,
Note:
64
b. Insert the alignment pins attached to the outer rail front flange into the
center opening in the rack.
install one M5 Torx screw in the lower location of the left rail. See
Do not install the upper left and the lower right screws until later.
Rear rail tray bracket (1 of 2)
2
Core Switch 2/64 V4.1 Installation Guide
1
2
SHR-2559A
Figure
15.
Advertisement
Table of Contents
