Table of Contents
Advertisement
Installing and Configuring the Core Switch 2/64
Checking POST Results
To verify that POST has completed, and the switch is operating normally:
70
Check that all LEDs have returned to a normal state after POST completes
(refer to
Chapter
3,
Interpreting LED
patterns and their meanings).
If one or more LEDs do not return to a normal state, (and this is not due to the
switch beaconing), use the slotShow command to check port status.
Verify that the switch prompt displays when POST completes. If it does not
display, POST was not successfully completed. Contact your switch supplier
for support.
Review the system log. Any errors detected during POST are written to the
system log, which is accessible through the errShow command.
Activity, on page 101, for specific LED
Core Switch 2/64 V4.1 Installation Guide
Advertisement
Table of Contents
