Table of Contents
Advertisement
Installing and Configuring the Core Switch 2/64
8. Insert the switch with the attached inner rails into the outer rails.
9. Install the two remaining M5 Torx screws to complete the installation. See
Note:
similar for istalling the screws in the Core Switch 2/64.
Figure 17: Installing switch into the HP rack
10. See the next section
66
Do not use any other screws other than the six that are provided.
Caution:
Use of any longer lengths can cause damage to internal components of the
switch. Before tightening screws, make sure that the rails are centered to the
overall height of the switch.
Figure
17.
Figure 17
shows installing the screws on a SAN Switch 2/16. The procedure is
instructions on applying power to the switch.
Powering On for the First Time
on page 67 for
Core Switch 2/64 V4.1 Installation Guide
SHR-2562A
Advertisement
Table of Contents
