HP AA-RS2WC-TE Installation Manual page 78

Installing and Configuring the Core Switch 2/64
3. Determine which CP card is active by entering the following command:
4. Configure the IP addresses for both CP cards, as follows.
Note:
card; although you can assign IP addresses to either CP card from a session with the
active CP card.
Note:
address must be used for both CP cards (these gateway addresses are referenced for
the logical IP addresses).
78
haShow
This command provides the following information:
switch:admin> haShow
Local CP (Slot 5, CP0): Active
Remote CP (Slot 6, CP1): Standby, Healthy
HA Enabled, Heartbeat Up, HA State not in sync
Configuration changes can only be made through a session with the active CP
a. If the CP card in slot 5 is not the active CP card, disconnect the serial
cable from the CP card, connect it to the CP card in slot 6, and log on as
Admin.
b. Enter the ipAddrSet command at the prompt, entering 2 for the CP
card in slot 5, and 3 for the active CP card in slot 6. For example:
ipAddrSet 2
c. Follow the onscreen prompts, and enter the appropriate information, as
shown in the following example (the default information for the CP card
in slot 5 is shown):
switch:admin> haShow
Ethernet IP Address [10.77.77.75]:
Ethernet Subnetmask [255.9.9.9]:
Host Name [CPQ]:
Gateway Address [0.0.0.0]:
The host name is the native name assigned to the CP card. The same gateway
Core Switch 2/64 V4.1 Installation Guide