Table of Contents
Advertisement
Setting Up and Configuring Modems
Setting Up a Remote Modem System
This section provides instructions for setting up a remote modem for testing
purposes, using a terminal emulation program on a computer that has an attached
modem.
This procedure is only required if a dial-out modem facility is not already
available for testing the Core Switch 2/64 modem connections.
Analog
Figure 47: Remote modem setup
To set up the optional remote modem:
1. Connect the remote modem to the workstation, as shown in
2. Disable any serial communication programs running on the workstation (such
3. Launch the terminal emulator application and configure as described below.
220
Ordinary PC
or
Running
Hyperterminal
as a synchronization program for a PDA).
Remote
DB-25M to DB-9F
Modem Cable
Figure
Core Switch 2/64 V4.1 Installation Guide
47.
Advertisement
Table of Contents
