Restoring the System Configuration Settings
Use these steps to restore the system configuration settings from a backup.
1. Verify that the RSHD service (on a UNIX machine) or the FTP service (on a
2. Log into the switch as the admin user.
3. Shut down the switch by entering the following command:
4. At the command line, enter the following command:
Note:
5. Reboot the switch by entering the following command:
SAN Switch 2/16 Version 3.1.x Installation Guide
Windows or UNIX machine) is running on the host workstation.
switchDisable
configDownload "hostIPaddr", "user",
"path_filename","password"
For example, hostIPaddr is the IP address of the host computer, user is the
User ID used to log into this computer, path_filename is the path location and
filename of the system configuration file, and password is the password for
the user ID specified.
The password operand is only required if you are using FTP.
fastBoot
Backing Up the Configuration and Upgrading Firmware
87