Table of Contents
Advertisement
Note:
orientation. If the transceiver does not slide in easily, ensure it is correctly oriented. For
instructions that are specific to the transceiver model, refer to the transceiver
manufacturer's documentation.
Figure 21: Connecting of a fiber cable
2. Position a cable so that the key (the ridge on one side of the cable connector)
3. Repeat
4. Organize the cables as required.
5. Check port status. Enter the following command at the telnet prompt:
Core Switch 2/64 V4.1 Installation Guide
Transceivers are keyed so that they can only be inserted with the correct
aligns with the slot in the transceiver, then insert the cable into the transceiver
until the latching mechanism clicks.
Cables are keyed so that they can only be inserted with the correct orientation.
If a cable does not slide in easily, ensure it is correctly oriented.
step 1
and
step 2
switchShow
This command provides detailed information about the switch.
Installing and Configuring the Core Switch 2/64
SHR-2517A
for the remaining ports.
83
Advertisement
Table of Contents
