Table of Contents
Advertisement
5. Configure the two logical IP addresses, as follows.
Note:
connection. HP does not recommend using it as a command interface during normal
operations because it only modifies one switch at a time (switch 0 by default).
Core Switch 2/64 V4.1 Installation Guide
The native IP address of the active CP card is updated immediately. The
native IP address of the standby CP card is updated at the next reboot.
d. Repeat steps 4a through 4c for the remaining CP card.
Resetting a logical IP address while the switch has active IP traffic
Caution:
such as Web Tools, Fabric Watch, SNMP, and other applications, may cause
them to terminate.
a. To configure the first logical IP address, enter the following command at
the prompt:
ipAddrSet 0
b. Follow the onscreen prompts, and enter the appropriate addressing
information:
Ethernet IP Address [10.77.77.77]:
Ethernet Subnetmask [0.0.0.0]:
Fibre Channel IP Address [none]:
Fibre Channel Subnet Mask [none]:
The logical IP address is updated immediately.
c. To configure the second logical IP address, enter the following command
at the prompt:
ipAddrSet 1
d. Follow the onscreen prompts, and enter the appropriate addressing
information, as described in step 5b.
e. Type reboot at the prompt to reboot the CP card.
The terminal serial port can be used to monitor error messages through a serial
f.
When complete, remove the serial cable.
g. Replace the serial port's protective cap.
Installing and Configuring the Core Switch 2/64
79
Advertisement
Table of Contents
