Table of Contents
Advertisement
Configuring Core Switch 2/64 Network Addressing
You must configure the Core Switch 2/64 to operate correctly within the network
and fabric. The following sections describe network addressing procedures.
Items Required
The following items are required to configure and connect the Core Switch 2/64:
Core Switch 2/64 V4.1 Installation Guide
Core Switch 2/64 powered on but not connected to a network or fabric
Workstation computer with a terminal emulator application (such as
HyperTerminal)
Serial cable provided with the switch
Ethernet cable
SFP transceivers and cables, as required
Two IP addresses for use as the "native" IP addresses assigned to the CP slots,
with the corresponding native host names, subnet masks, and gateway
addresses.
The default native IP addresses and host names are as follows:
— 10.77.77.75 CP0 (the CP card in slot 5 at the time of configuration)
— 10.77.77.74 CP1 (the CP card in slot 6 at the time of configuration)
Two IP addresses for use as the "logical" IP addresses of the switch, with the
corresponding subnet masks. These IP addresses correspond to switch 0,
which contains any 16-port cards in slots 1-4, and switch 1, which contains
any16-port cards in slots 7-10.
The default logical IP addresses are as follows:
— 10.77.77.77 sw0
— 10.77.77.76 sw1
Two switch names, if you do not use the default switch names.
Switch names can be up to 15 characters long, can include alpha, numeric,
and underscore characters, and must begin with an alpha character. The
default switch name for the logical switches are sw0 for the switch containing
the 16-port cards in slots 1-4, and sw1 for the switch containing 16-port cards
in slots 7-10.
Installing and Configuring the Core Switch 2/64
75
Advertisement
Table of Contents
