HP 10504 Installation Manual: Repackaging The Card

10500 switch series.
Hide thumbs

Advertisement

Repackaging the card

1.
Prepare the anti-static bag and box of the card. Make sure the bag is clean, dry, and not
damaged.
2.
Remove the transceiver modules from the card. If no transceiver module is installed on the card, go
to the next step.
For how to remove a transceiver module, see
3.
Remove all cards from the chassis slots, and install blank filler panels to the empty slots.
For how to remove a card and install a blank filler panel, see
4.
Put the card into the anti-static bag. The switching fabric modules for 10508, 10508-V, or 10512
switches have a protection box. Put the switching fabric module into the protection box, and then
put the box into the anti-static bag.
5.
Put the packed card into the box, and tape the flaps of the box with packing tape. Place the card
in a correct direction onto the foam cushion in the box. Otherwise, the power supply cannot be
completely seated into the foam cushion.
Repackaging the switch chassis
Removing the chassis from the rack
The switches are heavy. If possible, use a mechanical lift to move the switch.
To remove the chassis from the rack:
1.
Prepare the wooden carton and packing bag of the chassis. Make sure the carton and bag are
clean, dry, and not damaged.
2.
Remove the top cap and side panels from the wooden carton, and put the pallet base to a secure
place.
3.
As shown by callout 1 in
mounting brackets to the rack.
4.
As shown by callout 2 in
along the slide rails. When most part of the chassis is removed from the slide rails, lift up the
chassis by holding the handles at the chassis sides to completely remove the chassis from the rack.
"Replacement
Figure
59, use a Phillips screwdriver to loosen the screws that attach the
Figure
59, use a minimum of two people to slide the chassis outwards
100
procedures."
"Replacement
procedures."

Advertisement

This manual also for:

10508-v, 10508, 10512

Comments to this Manuals

Symbols: 0
Latest comments: