Repackaging The Card; Repackaging The Switch Chassis; Removing The Chassis From The Rack - HP FlexFabric 11908-V Installation Manual

2. Remove all power supplies from the chassis, and then install blank filler panels to the empty slots.
For how to remove a power supply and install a blank filler panel, see
3. Put the power supply into the bag.
4. Put the packed power supply and power cable into the box. Place the power supply in a correct
direction onto the foam cushion in the box. Otherwise, the power supply cannot be completely
seated into the foam cushion.

Repackaging the card

1. Prepare the anti-static bag and box of the card. Make sure the bag is clean, dry, and not
damaged.
2. Remove the transceiver modules from the card. If no transceiver module is installed on the card, go
to the next step.
For how to remove a transceiver module, see
3. Remove all cards from the chassis slots, and install blank filler panels to the empty slots.
For how to remove a card and install a blank filler panel, see
4. Put the card into the anti-static bag. The switching fabric module for the 11908-V switch has a
protection box. Put the switching fabric module into the protection box, and then put the box into
the anti-static bag.
5. Put the packed card into the box, and tape the flaps of the box with packing tape. Place the card
in a correct direction onto the foam cushion in the box. Otherwise, the power supply cannot be
completely seated into the foam cushion.

Repackaging the switch chassis

Removing the chassis from the rack

The switches are heavy. If possible, use a mechanical lift to move the switch.
To remove the chassis from the rack:
1. Prepare the wooden carton and packing bag of the chassis. Make sure the carton and bag are
clean, dry, and not damaged.
2. Remove the top cap and side panels from the wooden carton, and put the pallet base to a secure
place.
3. As shown in callout 1 in
mounting brackets to the rack.
As shown in callout 2 in
4.
slide rails. When most part of the chassis is removed from the slide rails, lift up the chassis by
holding the handles at the chassis sides to completely remove the chassis from the rack.
Figure 58, use a Phillips screwdriver to loosen the screws that attach the
Figure 58, use at least two persons to slide the chassis outwards along the
92
"Replacement procedures."
"Replacement
"Replacement procedures."
procedures."