Hardware Installation; Installing An Hp Blc Intel ® 4X Qdr Infiniband Managed Switch; Preparing The Interconnect Module Bay In The Hp Bladesystem Enclosure; Removing A Divider From The Hp Bladesystem Enclosure Interconnect Module Bay - HP BLc Intel 4X QDR InfiniBand Hardware Installation Manual

2

Hardware Installation

This chapter contains the following sections:
• "Installing an HP BLc Intel® 4X QDR InfiniBand Managed
• "Installing InfiniBand Cables in an HP BLc Intel® 4X QDR InfiniBand Managed
• "Removing an InfiniBand Cable from the HP BLc Intel® 4X QDR InfiniBand Managed
• "InfiniBand Subnet
Installing an HP BLc Intel
To install an HP BLc Intel
.
subsections
CAUTION: All panels and doors should be in place and securely fastened while the unit is in operation
for proper cooling and for EMI emissions control.

Preparing the Interconnect Module Bay in the HP BladeSystem Enclosure

To prepare the interconnect module bay in an HP BladeSystem enclosure, follow these steps:
1. Remove any devices or blanks.
2. To remove the divider, press the divider release button (see callout 1 in
out of the interconnect module bay (see callout 2 in
Figure 5

Removing a Divider from the HP BladeSystem Enclosure Interconnect Module Bay

Management"
®
4X QDR InfiniBand Managed Switch
®
4X QDR InfiniBand Managed Switch, follow
HP BLc Intel® 4X QDR InfiniBand Switch Hardware Installation Guide
Switch"
the steps in
Figure
Figure 5).
Switch"
Switch"
the following
5) and slide the divider
9