Table of Contents
Advertisement
April 2009
Entering Skan/Measure Count Parameters
To open the Skan/Measure Count window in the Skan/Measure
option, press the [ ] arrow key twice (from the All tab) to reach
the Count tab. Press
Figure 4-13 below.
All
Cycle Number
Measure Only
Minimum Noise Level
Low SNR Error Level
Figure 4-13: The Count Window in the
1. The first prompt asks for the Cycle Number that triggers the
count from 1 to 100. (The default number is 1.)
a. Press
[ENTER]
b. Use the numeric keys to enter the recommended number.
c. Press
[ENTER]
2. The meter now asks for the Cycle Width (# of cycle count
samples, minimum width of valid cycle).
a. Press
[ENTER]
b. Use the numeric keys to enter the recommended value.
c. Press
[ENTER]
4-30
[ENTER]
, and the screen appears similar to
Skan/Measure
Integrate
Count
Cycle Width
Noise Level
Cancel
Skan/Measure Option
to enter the text box.
to confirm the entry.
to enter the text box.
to confirm the entry.
Correlate
1
8
20
%
SNR Test
5 %
7
OK
Programming Site Data
Advertisement
Table of Contents
