Entering Pipe Parameters
To enter the Pipe option, scroll to the Pipe entry on the Program
Menu and press
scroll back up to the Transducer tab and press the [ ] arrow key
to reach the Pipe window and press
similar to Figure 4-3 below. To step through each parameter,
press the [
] key. Refer to Figure A-4 on page A-4 of Appendix
A, Menu Maps.
Note: Refer to the brochure Sound Speeds and Pipe Size Data
(914-004) for additional information about pipe sizes and
sound speeds.
Transducer
SndSpeed
OD, mm
Nominal
Figure 4-3: The Pipe Option Window
Programming Site Data
[ENTER]
. (From the Transducer window, you can
Transducer/Pipe
Lining
Pipe
Other
Material
600.3 m/s
OD x PI, mm
5
15.708
5
Schedule
Cancel
[ENTER]
.) The screen appears
Fluid
Path
Wall, mm
2
Schedule
ANSI
OK
April 2009
4-7