Table of Contents
Advertisement
April 2009
Entering the Service Menu
To enter the Service Menu, press the
right of the PT878GC keypad. The Main Menu replaces the
Status Bar at the top of the screen. Press the [ ] arrow key four
times to scroll from the Site Menu to the Service Menu. At the
Service Menu, press
9-1 below. When programming, refer to Figure A-10 on page A-
10 of Appendix A, Menu Maps.
Site Program Meter Logging
Velocity, ft/s
Units
Delta-T, ns
E0: No Errors
To scroll to a particular option, press the [
until you reach the option. Then press
window.
When entering parameters in an option, press:
•
The [ ] key to step through the available parameters.
•
The [ ] key to scroll back to a previously entered parameter.
•
[F2]
The
key (Cancel) or the
time and return to Operate Mode without changing the
parameters.
9-2
[ENTER]
. The screen appears similar to Figure
Test
0.00
0.10
Figure 9-1: The Service Menu
[ESC]
[MENU]
key at the lower
Service
Signal, dB
Reports
T-Gauge Display
32
T-Gauge Setup
Diagnostics
Calibrate
Signal Setup
Error Limits
Volume, l/s
Test
Factory Defaults
Flash Update
0.0
] or [
] arrow keys
[ENTER]
to open the option
key to exit an option at any
Servicing the PT878GC
Advertisement
Table of Contents
