Table of Contents
Advertisement
Installing DMP-1 Dampening Material with CFG-V
Series Fixtures (cont.)
7. With a marker, trace around the transducer footprint, as shown
in Figure 3-24 below.
Figure 3-24: DMP-1 Material with
8. Remove the fixture and transducers. Then use a utility knife to
cut out the area under the transducer footprint, and peel the cut
material off the pipe, as shown in Figure 3-25 below.
Note: Remove excess dampening material as soon as possible,
before it adheres to the pipe and becomes difficult to
remove.
Figure 3-25: DMP-1 Material with
9. To remove any residual adhesive, clean the cut-out area with a
rag or a piece of sandpaper, or use varnish remover.
10. Reinstall the fixture and transducers on the pipe.
Installing the Dampening Material, Transducers and Fixtures
Transducer Footprint Traced
Transducer Footprint Cut Out
April 2009
3-27
Advertisement
Table of Contents
