Table of Contents
Advertisement
Entering the Analog Output
The Analog Output option enables you to enter information to set
up output parameters. To enter the option, scroll to the Analog
Output entry on the Program Menu and press
appears similar to Figure 4-18 below. To step through each
parameter, press the [ ] key. Refer to Figure A-6 on page A-6 of
Appendix A, Menu Maps.
Figure 4-18: The Analog Output Window
1. The first prompt enables you to select a range to send a current
signal to a recording device.
a. Press
[ENTER]
b. Scroll to the desired output from three choices: Off,
0-20 mA, and 4-20 mA.
c. Press
[ENTER]
Note: If you select "Off," you cannot access any other
parameters in this option.
Programming Site Data
Analog Output
Function
Data Source
Zero
Span
On Error
Cancel
to open the drop-down menu.
to confirm your selection.
[ENTER]
0-20 mA
Velocity
m/s
0
25.5
Hold Last Value
OK
April 2009
. The screen
4-39
Advertisement
Table of Contents
