GE TransPort PT878GC User Manual page 233

Setting up Measurement Mode (cont.)
The first prompt asks for the measurement mode detection
method. Use the [ ] and [ ] arrow keys to move to the
appropriate radio button and press
You must now enter the setup data covered on page 4-23, if you
have not already done so. Pressing the [
"Skan/Measure Setup." Press
option and enter the parameters discussed on page 4-23.
You have completed entering data for the Measurement Mode. To
leave this window,
•
Press the [
and the [ ] arrow key to move to the Signal Parameter tab
or the [ ] arrow key to move to the Pulse/Code tab.
•
[F2]
Press
confirming the changes.
•
[F3]
Press
Operate Mode.
Servicing the PT878GC
[ENTER]
] key to return to the Measurement Mode tab,
(Cancel) to return to Operate Mode without
(OK) to confirm the new data and return to
[ENTER]
.
] key takes you to
to open the Skan/Measure
April 2009
9-29