Table of Contents
Advertisement
Setting up Signal Parameters (cont.)
5. The next prompt asks for velocity averaging, the number of
velocity measurements to average together to smooth out
noise in the system.
a. Press
[ENTER]
b. Use the [
number.
c. Press
[ENTER]
6. The final prompt, errors allowed, specifies the number of
errors the meter can record before displaying an error
message.
a. Press
[ENTER]
b. Use the numeric keys to enter the desired value.
c. Press
[ENTER]
You have finished entering data in the Signal Parameter window.
To leave this window,
•
Press the [
the [ ] arrow key to move to the Measurement Mode tab.
•
[F2]
Press
(Cancel) to return to Operate Mode without
confirming the changes.
•
[F3]
Press
(OK) to confirm the new data and return to Operate
Mode.
Servicing the PT878GC
to open the drop-down list.
] or [
] arrow keys to scroll to the desired
to confirm your selection.
to open the text box.
to confirm your entry.
] key to return to the Signal Parameter tab, and
April 2009
9-27
Advertisement
Table of Contents
