Programming the Thickness Gauge
While the T-Gauge Display option allows you to program the
appropriate material and sound speed, the Thickness Gauge Setup
option enables you to view or change five parameters:
•
Low Signal Threshold
•
Transducer Delay
•
Signal Inversion
•
Noise Threshold
•
Detection Threshold
IMPORTANT:
The Programming window appears similar to Figure 9-12 below.
Programming
Detection Threshold
Figure 9-12: The Thickness Gauge Programming Window
Servicing the PT878GC
The thickness gauge programming settings are
entered at the factory. You should not change
them unless instructed by GE Sensing.
Thickness Gauge Setup
Low Signal Thresh
Transducer Delay
Signal Inversion
Noise Threshold
Cancel
April 2009
0 %
µs
0
On
Off
%
0
0 %
OK
9-17