Entering Skan/Measure Integrate Parameters - GE TransPort PT878GC User Manual

April 2009

Entering Skan/Measure Integrate Parameters

To enter parameters for the Skan/Measure Integrate mode in the
Skan/Measure option, press the [ ] arrow key once to reach the
Integrate tab. Then press
which appears similar to Figure 4-12 below.
All
Measure Only
Figure 4-12: The Integrate Window in the Skan/Measure
1. The first prompt, A Divisor, is used in the calculation of the
Measure Mode integrated threshold level and is not normally
changed. The default value for this parameter is 2.5, and
values from 0.1 to 10 are acceptable.
a. Press
[ENTER]
b. Use the numeric keys to enter the recommended value.
c. Press
[ENTER]
2. Next, enter the Noise Level (-Offset % of Peak) from 0 to
95%, and press
a. Press
[ENTER]
b. Use the numeric keys to enter the recommended value.
c. Press
[ENTER]
4-28
[ENTER]
Skan/Measure
Integrate Count
A Divisor
Noise Level
Cancel
Option
to enter the text box.
to confirm the entry.
[ENT]
. (The default value is 20%.)
to enter the text box.
to confirm the entry.
to open the Integrate window,
Correlate
2.5
5 %
OK
Programming Site Data