April 2009
Making Electrical Connections
Before making measurements with the TransPort, you must make
all the necessary connections to the unit. This section describes
how to connect the following:
•
Power
•
Transducer
•
Analog Input/Output
•
Infrared Interface
Make all connections to the top of the TransPort unit as shown in
Figure 2-2 below. Please note that you only need to make the
proper transducer connections. The other connections are
required for particular functions, but are not necessary for basic
operation.
XDCR
Upstream
Figure 2-2: Connection Locations
2-2
Input/Output
(See Table 2-1
on page 2-4)
Downstream
Infrared
Transceiver
Power
Initial Setup