GE TransPort PT878GC User Manual page 95

Entering Skan/Measure Count Parameters (cont.)
3. The next prompt asks for the percentage of Noise Level.
a. Press
[ENTER]
b. Use the numeric keys to enter the recommended value.
c. Press
[ENTER]
4. If you wish to select (or deselect) Measure Times only
(instead of both Skan and Measure times), press
Measure Only prompt.
5. If you wish to select (or deselect) a SNR (signal-to-noise
ratio) test, press the [ ] key to highlight the SNR Test prompt
[ENTER]
and press
a. If you have selected SNR Test, the next prompt asks for the
Minimum Noise Level. Press
recommended value, and press
entry.
b. The final prompt asks for the Low SNR Error Limit. (The
default is 7.) Press
value, and press
Pressing the [ ] key returns the meter to the Cycle Number
entry, and pressing the [
tab.
•
To confirm the entries and return to Operate mode, press
(OK).
•
To leave the window without confirming the entries and return
to Operate mode, press
Programming Site Data
to enter the text box.
to confirm the entry.
.
[ENTER]
, type in the recommended
[ENTER]
to confirm the entry.
] key returns the meter to the Count
[F2]
(Cancel) or the
[ENTER]
[ENTER]
, type in the
[ENTER]
to confirm the
[ESC]
key.
April 2009
at the
[F3]
4-31