Table of Contents
Advertisement
Entering a Calibration Factor (cont.)
b. Enter the desired measurement and units as described on
page 4-40.
c. Press
[F3]
4. The prompt then asks if you wish to edit the K factor table.
a. Press
[ENTER]
Figure 4-27 below.
1
2
3
4
5
b. Use the numeric keys to enter the first value for the data
source, and press
c. Press the [ ] key to move to the KFactor column. Use the
numeric keys to enter the corresponding value, and press
[ENTER]
to confirm the entry.
d. Repeat steps b and c for the remainder of the table.
e. When you have completed entering values, press
to confirm the table and return to the Correction Factors
window.
Programming Site Data
(OK) to confirm your selection.
to open the table, which appears similar to
Edit KFactor Table
Data Source
Cancel
Figure 4-27: The KFactor Table
[ENTER]
Inputs
KFactor
to confirm the entry.
April 2009
0
OK
[F3]
(OK)
4-55
Advertisement
Table of Contents
