Table of Contents
Advertisement
Entering Transducer
Parameters
Programming Site Data
To enter the Transducer option, scroll to the Transducer tab on the
Program Menu and press
Figure 1-5 below. To step through each parameter, press the [
Refer to the Program Menu Map, Figure 1-34 on page 1-37.
Note: If the CTF878 does not scroll to a particular parameter, the
parameter is not necessary for that transducer type.
.
ransducer
Transducer
Transducer
Frq Up/Dn
Figure 1-5: Transducer Option Window
The next prompt asks you to enter the transducer number (printed on
the transducer itself), or to specify that you are using a special
application transducer.
1. From the Type prompt, press the [
[ENTER]
prompt, and press
2. A drop-down list of transducer numbers opens (see Figure 1-6
below). Press the [
number, or scroll to "Special" for a special application transducer.
3. Press
[ENTER]
to confirm your selection.
.
Transducer/Pipe
ansducer
Transducer
Transducer
Transducer
Frq Up/Dn
Figure 1-6: Transducer Type Options
[ENTER]
. The screen appears similar to
Transducer/Pipe
Transducer/Pipe
Pipe Fluid
Path
#304 (Shear)
0.500
0.471
Wedge Ang
35
Wedge Tmp
45 °C
Wedge SS
2480 m/s
Cancel
] key to reach the Transducer
.
] or [
] keys to scroll to the appropriate
p
Transducer/Pipe
Pipe Fluid
Path
#305 (Shear)
SPECIAL
#304 (Shear)
#305 (Shear)
#306 (Shear)
Cancel
February 2009
] key.
MHz
°
OK
Hz
OK
1-7
Advertisement
Table of Contents
