Table of Contents
Advertisement
April 2009
Specifying the Number of Displayed Parameters
As mentioned earlier, the PT878GC can display one to four
different measurement parameters simultaneously. However,
sometimes you might wish to display only one or two parameters.
To change the number of open display windows:
1. Press
[MENU]
2. From the Site Menu (shown in Figure 6-6 on page 6-8), use
the [
]or [
views (1 View, 2 Views, etc.) Press
The screen displays the designated number of windows. For
example, Figure 6-7 below shows the screen displayed in Figure
6-3 on page 6-4, reconfigured for a single view.
ABC.SIT
12.2
-12.2
E0: No Errors
Figure 6-7: Display Screen Configured for Single View
Note: The PT878GC opens display windows from the top; that
is, if you press "1 View," one parameter appears. If you
press "2 Views," two parameters appear, one on the top
and one on the bottom. The view for "3 Views" adds a
window in the lower right, and that for "4 Views" sends
the second parameter to the upper right corner, with the
third parameter in the lower left and the fourth parameter
in the lower right.
6-10
.
] arrow keys to move to the desired number of
2000/11/30 09:53 AM
Velocity, ft/s
-0.6014
10 Seconds
[ENTER]
.
Displaying and Configuring Data
Advertisement
Table of Contents
