Table of Contents
Advertisement
April 2009
Entering Reynolds Correction (cont.)
b. Enter the desired measurement and units as described on
page 4-40.
c. Press
[F3]
4. The prompt then asks if you wish to edit the Reynolds
Correction table.
a. Press
[ENTER]
Figure 4-25 below.
1
2
3
4
5
Figure 4-25: Window for Reynolds Correction Table
b. Use the numeric keys to enter the first value for the data
source, and press
c. Press the [ ] key to move to the Reynolds value column.
Use the numeric keys to enter the corresponding value, and
[ENTER]
press
d. Repeat steps b and c for the remainder of the table.
4-52
(OK) to confirm your selection.
to open the table, which appears similar to
Edit Reynolds Table
Data Source
Cancel
[ENTER]
to confirm the entry.
Inputs
Re
to confirm the entry.
Programming Site Data
0
OK
Advertisement
Table of Contents
