Table of Contents
Advertisement
The Measurement Option
On occasion, you might need to change the actual parameter
measured in a given window.The Measurement option enables
you to reconfigure the window with one of five categories of data
source (velocity, volume, forward or reverse totalizer, or
diagnostics) and appropriate English or metric measurement
units.
To enter the Measurement option:
1. Press
[SEL]
from the Operate Mode window until you have
reached the desired measurement.
2. Press
[ENTER]
3. Be sure the Measurement option is highlighted, and press
[ENTER]
.
The screen appears similar to Figure 6-5 on page 6-8. The left
column displays the measurement data sources, while the right
column displays English and metric measurement units (or, with
the Diagnostics source shown, a list of diagnostics parameters).
4. Use the [
] and [
source, and press
5. Then use the [
measurement unit (or diagnostic parameter).To speed
scrolling, you can press the [ ] key to scroll down by a page,
or the [ ] key to scroll up by a page. Press
confirm the entry.
6. The screen returns to Operate Mode, and displays any
changes.
Displaying and Configuring Data
to open the Display Menu.
] arrow keys to reach the desired data
[SEL]
.
] or [
] arrow keys to select the desired
April 2009
[F3]
, OK, to
6-7
Advertisement
Table of Contents
