Table of Contents
Advertisement
Entering Pipe Lining Parameters
To enter the Lining option, scroll to the Lining entry on the
Program Menu and press
can scroll back up to the Pipe tab and press the [ ] arrow key to
reach the Lining window, and press
similar to Figure 4-4 below. To step through each parameter,
press the [ ] key. While programming, refer to Figure A-3 on
page A-3 of Appendix A, Menu Maps.
Note: The Lining option is only available for clamp-on
transducers.
Transducer
Sound Speed
Figure 4-4: The Pipe Lining Window
1. The PT878GC first prompts you to select the pipe lining
material.
a. Press
[ENTER]
materials.
b. Scroll to the appropriate material. If you do not see your
lining material on the list, select "Other."
c. Press
[ENTER]
Programming Site Data
[ENTER]
. (From the Pipe window, you
Transducer/Pipe
Pipe
Lining
Tar/Epoxy
Material
2000
Thickness
Cancel
to open the drop-down list of lining
to confirm your choice.
[ENTER]
.) The screen appears
Path
Fluid
m/s
0
mm
OK
April 2009
4-11
Advertisement
Table of Contents
