Entering the Digital Output (cont.)
If you entered Test Points:
The prompt asks for the signal type from two choices: transmit or
receive.
a. Press
[ENTER]
b. Scroll to the required signal.
c. Press
[ENTER]
If you entered Gate Input:
1. The first prompt asks for the gate active.
a. Press
[ENTER]
b. Scroll to the gate, either Contact Open or Contact Closed.
c. Press
[ENTER]
2. The remaining prompt asks for the mode, automatic or
manual.
a. Press
[ENTER]
b. Scroll to the required mode.
c. Press
[ENTER]
Stopwatch Totalizer
Through the Gate Input option, you can implement the
Stopwatch Totalizer function to measure totals manually. To set
up the Totalizer function:
1. At the Gate Active prompt, select Contact Closed.
2. At the Mode prompt, select Manual, and press
The stopwatch icon (see page 2-11) appears in the system tray. To
start or stop the function, press the minus (-) key on the keypad.
You have completed entering parameters in the Digital Output
option.
•
To confirm the entries and return to Operate mode, press
(OK).
•
To leave the window without confirming the entries, press
(Cancel) or the
Programming Site Data
to open the drop-down menu.
to confirm your selection.
to open the drop-down menu.
to confirm your selection.
to open the drop-down menu.
to confirm your selection.
[ESC]
key.
April 2009
[ENTER]
.
[F3]
[F2]
4-45