Entering The Service Menu - GE PM880 Operations & Installation Manual

August 2003

Entering the Service Menu

To enter the Service Menu, press the
right of the PM880 keypad. The Menu Bar replaces the Status
Bar at the top of the screen. Press the [ ] arrow key four times to
scroll from the Site Menu to the Service Menu. At the Service
Menu, press
[ENTER]
below. When programming, refer to Figure B-6 on page B-6 of
Appendix B, Menu Maps.
Site Program Meter Logging
Dew Point, °C
Units
Pressure, PSIg
About
Figure 8-1: The Service Menu
To scroll to a particular option, press the [
until you reach the option. Then press
window.
When entering parameters in an option, press:
•
The [ ] key to step through the available parameters.
•
The [ ] key to scroll back to a previously entered parameter.
•
The key (Cancel) or the
[F2]
time and return to Operate Mode without changing the
parameters.
8-2
. The screen appears similar to Figure 8-1
Test
-52.0
55.00
[ESC]
key at the lower
[MENU]
Service
Signal, dB
Reports
Test
32
References
MIS Probe
Factory Defaults
Flash Update
Run Time, Hours
Security Settings
Factory Calibration
0 6
] or [
to open the option
[ENTER]
key to exit an option at any
Servicing the PM880
12
] arrow keys