Table of Contents
Advertisement
February 2009
Entering the Program
Menu
1-6
To enter the Program Menu, press the
the CTF878 keypad. The Menu Bar replaces the Status Bar at the top
of the screen. Press the [ ] arrow key once to scroll from the Site
Menu to the Program Menu. At the Program Menu, press
The screen appears similar to Figure 1-4 below. While following the
programming instructions, see the Program Menu Map, Figure 1-34
on page 1-37.
Program
Site
Transducer
Pipe
Fluid
Path
IO
Standard Volume
User Functions
Correction Factors
0
50
Figure 1-4: Program Menu
To scroll to a particular option, press the [
you reach the option. Then press
When entering parameters in an option, press:
•
The [
] key to step through the available parameters
•
The [
] key to scroll back to a previously entered parameter
•
[F2]
The
key (Cancel) or the
and return to Operate Mode without changing the parameters.
Note: The Transducer, Pipe, Fluid and Path parameters are
categorized under the same Transducer/Pipe menu, as shown
in Figure 1-5 below. You can be more time-efficient by
programming the parameters in all four entries under
Transducer/Pipe before exiting the menu.
When you are highlighting a parameter in one of the four entries, and
you wish to go to another entry:
1. Use the [
] key to scroll up to the current tab (the entry that you
are under).
2. Press the [ ] or [ ] key to select the parameter you want to
ENTER
access, then press [
[MENU]
key at the lower right of
Meter
Logging
Service
elocity, m/s
Cross Corr
100
]or [
] arrow keys until
[ENTER]
to open the option window.
[ESC]
key to exit an option at any time
].
Programming Site Data
[ENTER]
.
Advertisement
Table of Contents
