Table of Contents
Advertisement
Dashboard
Dashboard Center Panel Removal/Installation
NOTE:
• Put on gloves to protect your hands.
• When prying with a flat-tip screwdriver, wrap
it
with
protective tape, and apply protective tape around the
related parts, to prevent damage.
• Take care not to scratch the dashboard and related
parts.
1. Make sure you have the anti-theft code for the radio,
the write down the frequencies for the preset
buttons.
2. Remove these items:
Driver's dashboard lower cover (see page
20-59)
Passenger's dashboard lower cover (see page
20-63).
Glove box (see page
20-63).
Shift lever trim (see page
20-61).
3. From the glove box and driver's dashboard lower
cover openings, loosen the bolts
(A)
securing the
center panel
(8).
Fastener Locations
A~:
Bolt, 2
~
20-62
5xO.8mm
5N·m
10.5 kgf·m, 4Ibf·ft)
4. Pull out the center panel (A) to release the clips (8)
and hooks (e), and remove the harness holder (D)
from the bracket (E). Disconnect the audio unit
connector (F), antenna lead (G), heater switch
connector (H) and heater control unit connectors (I).
Fastener Locations
Be>: Clip, 8
~:
,'"
:
H
o
G
5. Install the panel in the reverse order of removal,
and note these items:
C
Make sure each connector is plugged in properly,
and antenna lead is connected properly.
Push the clip portions into place securely.
Reconnect the negative cable to the battery.
Do the EeM/peM idle learn procedure (see page
11-139).
Enter the anti-theft code for the radio, then enter
the customer's radio station presets .
• Reset the clock.
Advertisement
Table of Contents
Troubleshooting
