Short To Power In Front Passenger's Airbag Inflator - Honda Civic 2002-2003 Service Manual

Table of Contents

Advertisement

,
J
DTC 2·4: Short to Power in Front Passenger's
Airbag Inflator
Special Tools Required
• SRS inflator simulator 07SAZ-TB4011A
• SRS simulator lead F 07XAZ-SZ30100
1. Erase the DTC memory (see page 23-26).
2. Turn the ignition switch ON (II), and check that the
SRS indicator comes on for about 6 seconds and
then goes off.
Does the SRS indicator stay on?
YES~Go
to step 3.
NO~lntermittent
failure, system is OK at this time.
Go to Troubleshooting Intermittent Failures (see
page 23-26).
3. Turn the ignition switch OFF. Disconnect the
battery negative cable, and wait for 3 minutes.
4. Disconnect the front passenger's airbag 4P
connector (A) from dashboard wire harness B.
A
07SAZ-TB4011A
-~
~-~
~
0::
07XAZ-SZ30100
5. Connect the SRS inflator simulator (2
Q
connectors) and the simulator lead F to dashboard
wire harness B.
6. Reconnect the battery negative cable.
7. Erase the DTC memory.
8. Read the DTC.
Is DTe 2-4 indicated?
YES~Go
to step 9 .
NO~Short
to power in the front passenger's airbag
inflator; replace the front passenger's airbag (see
page 23-114) .•
9. Turn the ignition switch OFF. Disconnect the
battery negative cable, and wait for 3 minutes.
10. Disconnect the driver's airbag 4P connector from
the cable reel (see step 2 on page 23-21).
11. Disconnect both seat belt tensioner 2P connectors
from the floor wire harness (see step 5 on page 23-
22).
(cont'd)
23-45

Advertisement

Table of Contents

Troubleshooting

loading

Table of Contents