Piston, Pin And Connecting Rod Replacement - Honda Civic 2002-2003 Service Manual

Engine Block
Piston, Pin, and Connecting Rod Replacement
Disassembly
1. Remove
the piston from the cylinder block (see
page 7-12).
2. Apply engine oil to the piston pin snap rings (A),
and turn them in the ring grooves until the end
gaps are lined up with the cutouts in the piston pin
bores (8).
NOTE: Take care not to damage the ring
grooves.
A
B
I~
iL
3. Remove
both snap rings (A). Start at the cutout in
the piston pin bore. Remove the snap rings
carefully so they do not go flying or get lost. Wear
eye protection .
.
~ •...
-::
...
=_--:0- ____ --
A
7-18
4. Heat the piston and connecting rod assembly to
about 158°F 170°C), then
remove
the piston pin.