Honda Civic 2002-2003 Service Manual page 1090

8. Read the DTC.
Is DTC 11-3 indicated?
YES-Go to step 9.
NO-Short to another wire in the driver's side
airbag inflator; replace the driver's side airbag Isee
page 23-1151 .•
9. Turn the ignition switch OFF. Disconnect the
battery negative cable, and wait for 3 minutes.
10. Disconnectthe front passenger's side airbag 2P
connector Isee step 4 on page 23-211 and both seat
belt buckle tensioner 4P connectors Isee step 6 on
page 23-221.
11. Disconnectthe special tool from the floor wire
harness 2P connector.
12. Disconnect SRS unit connector B 118PI from the
SRS unit Isee step 7 on page 23-221.
13. Check resistance between the No.6 and No. 17
terminals of SRS unit connector B 118PI. There
should be an open circuit, or at least 1 M Q.
SRS UNIT CONNECTOR B (18PI
WHT/BLU
WHT/BLK
Wire side of female terminals
Is the resistance as specified?
YES-Faulty SRS unit; replace the SRS unit Isee
page 23-1221 .•
NO-Short to another wire in the floor wire
harness; replace the floor wire harness .•
OTe 11-4: Short to Power in Driver's Side
Airbag Inflator
Special Tools Required
• SRS inflator simulator 07SAZ-TB4011A
• SRS simulator lead E 07XAZ-S1A0200
1. Erase the DTC memory Isee page 23-261.
2. Turn the ignition switch ON 1111, and check thatthe
SRS indicator comes on for about 6 seconds and
then goes off.
Does the SRS indicator stay on?
YES-Go to step 3.
NO-Intermittent failure, system is OK at this time.
Go to Troubleshooting Intermittent Failures (see
page 23-261.
3. Turn the ignition switch OFF. Disconnect the
battery negative cable, and wait for 3 minutes.
4. Disconnect the floor wire harness 2P connector (A)
from the driver's side airbag.
o
A • /07SAZ-TB4011A
~~A
07XAZ-S1A0200
-w
5. Connect the SRS inflator simulator 12
Q
connectorl
and simulator lead E to the floor wire harness.
Icont'dl
23-83