Honda Civic 2002-2003 Service Manual page 1072

6. Reconnect the battery negative cable.
7. Erase the DTC memory.
8. Read the DTC.
Is DTC 22-1 indicated?
YES-Go to step 9.
NO-Open or increased resistance in the front
passenger's seat belt buckle tensioner; replace the
front passenger's seat belt buckle .•
9. Turn the ignition switch OFF. Disconnect the
battery negative cable, and wait for 3 minutes.
10. Disconnect both side airbag 2P connectors (see
step 4 on page 23-21) and the driver's seat belt
buckle tensioner 4P connector (see step 6 on page
23-22).
11. Disconnect SRS unit connector B (18P) from the
SRS unit (see step 7 on page 23-22). Do not
disconnectthe special tool from the floor wire
harness.
12. Check resistance between the No.2 and No. 11
terminals of SRS unit connector B (18P). There
should be 2.0-3.0
Q.
SRS UNIT CONNECTOR B Il8PI
Wire side of female terminals
Is the resistance as specified?
YES-Faulty SRS unit or poor contact at SRS unit
connector B (18P) and the SRS unit. Check the
connection; if the connection is OK, replace the
SRS unit (see page 23-122) .•
NO---Open or increased resistance in the floor wire
harness; replace the floor wire harness .•
DTe 22-3: Short to Another Wire or
Decreased Resistance in Front Passenger's
Seat Belt Buckle Tensioner
Special Tools Required
• SRS inflator simulator 07SAZ-TB4011A
• SRS simulator lead F 07XAZ-SZ30100
1. Erase the DTC memory (see page 23-26).
2. Turn the ignition switch ON (II), and check that the
SRS indicator comes on for about 6 seconds and
then goes off.
Does the SRS indicator stay on?
YES-Go to step 3.
NO-Intermittent failure, system is OK at this time.
Go to Troubleshooting Intermittent Failures (see
page 23-26).
3. Turn the ignition switch OFF. Disconnect the
battery negative cable, and wait for 3 minutes.
4. Disconnect the front passenger's seat belt buckle
tensioner 4P connector (A) from the floor wire
harness.
o
5. Connect the SRS inflator simulator (2
Q
connectors) and the simulator lead F to the floor
wire harness.
6. Reconnect the battery negative cable.
7. Erase the DTC memory.
(conl'd)
23-65