Driver's Window Motor Test; Pulser Test - Honda Civic 2002-2003 Service Manual

Driver's Window Motor Test
Motor Test:
,. Remove the door panel (see page 20-4).
2. Disconnect the 4P connector (A) from the driver's
window motor.
Terminal side of
male terminals
3. Test the motor in each direction by connecting
battery power and ground according to the table.
When the motor stops running, disconnect one
lead immediately.
\ Terminal
1 2
Direction
\
UP
e
c±l
DOWN
c±l
e
4. If the motor does not run or fails to run smoothly,
replace it.
Pulser Test:
1. Reconnect the 4P connector to the driver's window
motor, and reconnect the 20P connector to the
power window master switch.
2. Connect the test leads of a voltmeter to the No.3
and No.4 terminals of the driver's window motor
4P connector.
3. Run the motor using the master switch. The
voltmeter should read about 6
v.
4. If the voltage is not as specified, check for an open
in the wires. If the wires are OK, replace the driver's
window motor.
22-129