Passenger's Window Switch Input Test - Honda Civic 2002-2003 Service Manual

Power Windows
Passenger's Window Switch Input Test
1. Remove the switch panel (see page 20-41.
2. Disconnect the 5P connector (A) from the switch (B).
A
Wire side of female terminals
BLU/WHT
B
RED/BLU
BLU/RED
GRN/BLK
3. Input the connector and socket terminals to be sure they are all making good contact.
Ifthe terminals are bent, loose or corroded, repair them as necessary, and recheck the system.
If the terminals look OK, go to step 4.
4. Reconnect the connector, and using a back probe, make these input tests at the connector. If any test indicates a
problem, find and correct the cause, then recheck the system.
Cavity
Wire Test condition Test: Desired result Possible cause if result is not obtained
3 GRN/BLK Ignition switch ON Check for voltage to
·
Blown No. 6(7 .5A) fuse in the
(II)
ground: under-dash fuse/relay box
There should be battery
·
Blown No. 22 (20A) fuse in the
voltage. under-dash fuse/relay box
·
Faulty power window relay
• An open in the wire
• Poor Qround (G201)
2 BLD/WHT Ignition switch ON I Check for voltage to
• Faulty master window switch
(II)
ground:
I •
An open in the wire
Althe master There should be battery
window switch, voltage.
press and hold I
down the
passenQer's
swit~h
4 BLU/RED Ignition switch ON Check for voltage to
• Faulty master window switch
(II)
ground: • An open in the wire
I
At the master
There should be battery
I
wi ndow switch,
voltage.
pull up and hold
the passenger's
switch
22-130