Table of Contents
Advertisement
•
•
8. Using a fiat-tip screwdriver wrapped with
protective tape, insert
it
into the hook portions
(seven places)
of the
headrest rear trim (A) from the
headrest front trim side. Pry up the hooks (8) to
release the tabs
(e)
of the headrest front trim (0)
while pulling the headrest front trim forward, and
remove the trim.
9. Unzip the headrest portion of the seat-back cover
(A), then remove the zipper (8), and remove the
cover.
B
10. Install the cover in the
reverse
order of removal,
and note these items:
Fit all the hooks of the headrest front trim into the
holes in the headrest rear trim, then push on the
headrest trim until the hooks snap into place .
• To prevent wrinkles when installing a seat-back
cover, make sure the material is stretched evenly
over the pad before securing the clips, hooks,
and hook springs.
Make sure the side airbag harness, OPOS
harness (passenger's seatL and rear seat access
cable (passenger's seat) are routed properly.
If necessary, reinitialize the OPOS control unit
(see page 23-124).
(conl'd)
20-77
Advertisement
Table of Contents
Troubleshooting
