Honda Civic 2002-2003 Service Manual page 1109

SRS
DTe Troubleshooting (cont'd)
23. Turn the ignition switch OFF.
24. Remove the gauge assembly Isee page 22-641.
With the connectors stili connected to the gauge
assembly, backprobe the No. 15 terminal of gauge
assembly connector A 122PI.
25. Turn the ignition switch ON (II).
26. Check for voltage between the No. 15 terminal of
gauge assembly connector A 122PI and body
ground. There should be battery voltage.
GAUGE ASSEMBLY CONNECTOR A (22P)
11 12 13 14 22
=
Wire side of female terminals
Is there battery voltage?
YES~Go to step 27.
NO~Go to step 31.
27. Turn the ignition switch OFF.
28. Disconnect floor wire harness 6P connector C509
IAI from dashboard wire harness.
A
23-102
29. Turn the ignition switch ON III).
30. '02 model: Check for voltage between the No.4
terminal of dashboard wire harness A 6P connector
C509 and body ground. There should be battery
voltage.
'03 model: Check for voltage between the No.5
terminal of dashboard wire harness A 8P connector
C509 and body ground. There should be battery
voltage.
'02 Model:
DASHBOARD WIRE HARNESS A 6P CONNECTOR
=
Terminal side of male terminals
'03 Model:
DASHBOARD WIRE HARNESS A 8P CONNECTOR
=
Terminal side of male terminals
Is there battery voltage?
YES-Poor contact at the dashboard wire harness
A 6P or 8P connector and floor wire harness, an
open in the floor wire harness, or an open in the
OPDS unit harness. Check the connection; if the
connection is OK, replace the faulty harness .•
NO-Poor contact at gauge assembly connector A
(22P) or an open in dashboard wire harness
A.
Check gauge assembly connector A (22PI; if the
connections are OK, replace dashboard wire
harness
A..